Questions & Answers for: thumb screw Sewing Machines

...thumb screw that tightens and holds the needle ..that might be missing .. make sure you have the correct type needle ... the little thumb screw should tighten down the needle if its assembled ...

...thumb screw on the right side of the needle clamp. 2 - The old needle wil probably fall out, if not you can simply pull it straight down to remove it. 3 - Slide a new needle up into the needle clamp. ...

thumb screw at the back of the foot and sliding foot to the left of the needle. If the raised edge is to the left, slide foot to right. 4. With presser foot down, check its position by lowering needle

...thumb-screw was tightened. Or, the needle may be bent.  Try a new needle and carefully mount it and make sure it is all the way up the channel and straight before tightening the thumb screw.Make ...

...thumb screw on the needle bar that holds the needle in place. Turn anticlockwise to undo. Remove needle, and place a new one into the housing, flat shank to the back, and holding it all the ...

...thumb screw that holds the snap on foot holder.... and place your foot making sure the needle holder thumb screw holds the lever on the other side.  And tighten the thumb screw to hold on the ...

thumb screw by the needle. Just unscrew it enough to be able to remove the needle by pulling straight down. You may need a small screw driver. HOWEVER, when you take the needle out, by pulling it down

...thumb-screw right where the needle joins the needle mechanism. Loosen the thumb-screw and catch the broken needle when it falls out. Put a new needle in the place occupied by the broken needle. Be ...

...Thumb Screw is appropriate for your machine. If not try other sewing machine thumb screws that may work better. 2. Check/Verify the plastic foot is the correct configuration to work on your machine. ...

...thumb screw on the presser foot shank as you lock in the presser foot. For one-piece presser feet, loosen the thumb screw and let the foot down. Then tighten the thumb screw around the shank of the ...