Questions & Answers for: tighten valve cover gaskets ford

...There should be some bolts surrounding the valve cover(s). Take them out take the valve cover off clean it up good put new gasket on put bolts back in tighten from center out so valve cover don't ...

remove the valve cover bolts. remove the valve cover. scrape off the old gasket material off the cover and the engine. put the new gasket in place and replace the bolts and tighten...dont over tighten

...from high up on the right bank of the enging above the where the header pipes merge. Can't see up there but it could be the valve cover, timing cover or head seapage. Any ideas? Valve cover

...to lift up the valve cover/ clean the lid/ put a new gasket and put silicone gasket sealant on the edge of half moon rubber gasket to avoid leak/ tighten the bolts/ put the plugs and wire

Ford escape with the 3.0 v6. Can I do this without pulling the engine? just try tightening the bolts first ,the gasket compresses with age , YEP YOU HAVE TO REMOVE FLEXIBLE EXHAUST PIPE.AND DISCONNECT

2005 Ford Escape Valve Cover Gasket FIX remove the valve cover and replace the gasket... if its the rear you need to pull the upper intake

...the oil pan gasket, or rear valve cover gasket,not uncommon for the Escape or the passengerside cv boot or transmission seal, you would have identify exactly where its coming from under the

...gasket on a 2003 Ford Expedition 5.4 unscrew the coils remove them by pulling up. remove valve cover bolts pull off cover. remove old gasket and replace. tighten cover bolts then re install the

...valve cover. Clean sparkplug wires connectors.. Try Rockauto .com for this part about $25. about 1/2 price of local auto parts store. Tighten Valve cover screws to correct torque specs.. for best

valve cover and intake plenum for a 2003 escape changing plugs and gaskets Its not the torque witch will in most cases will be under 10 FT LBS its the order that you tighten then that's important. You