...kill switch i have a kawasaki zx9r 1998 . seler told me had to get new kill switch did that started bike and now fried the kill switch ! could u tell me if it would be rectifier , or bad ground or ...
Question about 2005 CBR 1000 RR Fireblade
...kill switch circuitry.. the tilt switch could have been tripped when fixing you clutch line. i heard that you can reset it by cycling the kill switch, turn key on cycle switch, then try again. The ...
...kill switch #2 kickstand switch and #3 tilt/bank angle switch. since im almost positive you didnt hit the kill switch will let that one go and if you didnt hit a large speed bump or pot hole you ...
tilt sensor that will kill the engine when you have to lay the bike down. That may have been damaged, also check your kill switch on the handle bar to ensure that it is not at fault. Also check on the
...9.9 yamaha tiller arm disconnect throttle cables and kill switch , tilt arm up and where it pivots on the back there is a plate with a couple of bolt or a large nut to remove and it then comes off
...wont work has no power to the fuel pump check the fuel pump fuse and relay, we had a pontiac that the ignition switch was bad and just tilting the steering wheel would kill the power to the fuel
...tilt working before realizing I had a kill switch at ignition. got my motor starting and running good now but now I have no tilt working or my lights. wondering are they a kill switch somewhere else? ...
Question about 2010 Downtown
...tilt switch? Thank you very much Check the kill switch on the handle bars I have had them short out and also check the wire from the kill switch to the plug in on the bike. if that is good it maybe ...
Question about 2010 Downtown
...yamaha 200 hp four stroke outboard kills when tilt switch is engaged motor runs fine otherwise trim also works with motor off? look for a loose wire in the control box where shifter and tilt switch ...
Question about 2010 Downtown
...tilt relay looked burnt out n was an odour to . Can't fathom how a tiny relay cause this to die in it's tracks check and test kill switch safety --- but if wiring burnt check for short -- fix and ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions