Questions & Answers for: time butterflies

...not as good as I wanted. The next time I mess with it I'm going to modify it so I can turn a tiny little screw to sync the butterflies. A modification like that is desperately needed for the Quota.

...of the throttle body. Using throttle body cleaner open the butterfly and clean out. The first few times you may have difficulty starting but clean it a few more time to see if this clears up ...

i have a 2007 ford explorer. sometimes (not all the time) when i first start it, it idles rough. then it smoothes right out. it runs fine. it only has 40000 miles on it. can u help? thanx clean the ...

...do not remove butterfly just carefully clean it where it is and allow about 10 minutes drying time before restart it will run rough at first until it burns out access carb cleaner then it

...around the butterfly pivot pin, and the area where the butterfly sits in closed position. Over time, these areas are bad about carbon build-up. Once carbon gets built up, the butter fly can't ...

Its getting fuel its got enough juice to start but it just keeps turning over and over. OOPPPSSS... time to take it to the dealer that installed the butterfly throttle and let them fix it... tell your

Ruff idle after replacing timing belt plugs and valve cover gaskets. Butterflys raddle at idle with three bushings missing of of the butterflys which is def where noise. CHECK TIMINCAGAIN ROLL TO TDC ...

...and look and see if they are all opening and closing together and gaps same after several times ! should be correct if all links are ok ! final tickover setting when fitted on bike to about ...

How do I set time on unit To set the time do the following: Turn meter on without test strip. Press the time for 3 seconds. Select 12 or 24 hour clock use up and down arrows to change, then press the ...