Questions & Answers for: tomtom screws

Question about ONE GPS Receiver

1 Answer

...TomTom. I have removed the 4 screws on the back. Are there more screws? Barry There are 4 screws: 1. Remove front bezel 2. unscrew 4 small screws (1 hole has anti tamper tape over) 3. remove "dome" ...

Ad

Big X on tomtom screen..and not functioning. When doing a backup and synchronization, my tomtom, got screwed up. Now when I power it up, i just get the stupid tomtom sound, and a big X on the screen. ...

Ad

Question about One Europe v2 GPS Receiver

1 Answer

...screws out of back of tomtom ( these are star screws so you will need a special tool but sometimes an allen key will fit. ) At the top / side of the tomtom where you can see the join of plastic ...

Question about ONE GPS Receiver

3 Answers

...screws from the back of hte device, but i cant get the tomtom to come apart? whats the trick to disassembly after the screws are removed? thanks Jim I, mine gps do not succeed to load with the cable ...

...tomtom rider 1. There are 3 sizes of Torx screws; 3 sets of 2 screws each. The largest is at the top back. I watched a fellow on YouTube take the back off. That was very helpful. Someone called that ...

TomTom Go 720 I need to reset to factory settings I need to reset my TOMTOM GO 720 to factory settings. Cause I have screwed it up..... Did you try the reset button on the bottom??? Dan

Question about GO 720 GPS Receiver

2 Answers

tomtom) for about 10GBP. They are easy to replace - 4 screws on back of 710, pop out main unit, and remove 4 screws holding speaker, unplug and install new one - reverse to assembly once more. I had a

Question about GO 910 GPS Receiver

2 Answers

where is clear flash tool you can get the TomTom Clear Flash tool Here just follow the instructions on the download page. tomtom home must be closed when running the flash tool. i have my tomtom home ...

TomTom 720, they are very similar but don't believe you disassemble the the same. I've tried to get to the battery by removing the glass screen but the screws are impossible to get to and I also tried

Question about GO 730 Car GPS Receiver

2 Answers

...screws at the rear of the unit. Then gently push out the front section through the screw holes. Release the front section and inside will be the motherboard which has four more torx srews. Open those ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top GPS Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66963 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a GPS Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...