Question about 2005 FLHTCUI Electra Glide Ultra Classic
...2 into 1 exhaust. I would like to know the "ft lbs" / "in lbs" of torque for the flanges. I also have a Screaming Eagle stage 1 intake and wish to instal a Ride Maxx Plus. Are the downloads preloaded ...
Question about 2003 FLSTC Heritage Classic
...torque settings for a head on a bmw 318is e36 and the sequence BMW cylinder torque setting all models According to my service manual as follows. Cyl head to engine block (torx e12 M10 bolts) Stage 1 ...
...torque specifications for all late models 2000 and up where applicable. 1. Front axle nut 50-55 ft lbs. 2. Front fork slider cap nuts 11-15 ft lbs. 3. Front fork pinch bolt 30-35 ft lbs. 4. Rear axle ...
torque settings for the fork stem nut, axle, handle bar riser, front caliper and front fender on a 2007 harley davidson dyna low rider fxdl Hi Jokerindeath, and your torque specs are: 1. 1/4" bolts 10
Question about 2008 FLHTCU Ultra Classic Electra Glide Peace Officer
...and your torque specifications are: 1. 1/4" bolts 10 ft lbs. 2. 5/16" bolts 20 ft lbs. 3. 3/8" bolts 35 ft lbs. 4. 7/16" bolts 55 ft lbs. 5. 1/2" bolts 75 ft lbs. Good luck and have nice
Question about 2008 FLHTCU Ultra Classic Electra Glide Peace Officer
torque. 2, Tighten each bolt to 12-14 foot pounds of torque. 3. Mark each head bolt and head with aligning marks. Tighten each bolt 1/4 turn (90 degrees). Cylinder Head Bolt Installation Torque Wrench
Question about 2008 FLHTCU Ultra Classic Electra Glide Peace Officer
...glide Hi Neilcobde712, and your torque specifications are: 1. 1/4" bolts 10 ft lbs. 2. 5/16" bolts 20 ft lbs. 3. 3/8" bolts 35 ft lbs. 4. 7/16" bolts 55 ft lbs. 5. 1/2" bolts 75 ft lbs. Have nice
Question about 2009 FXD Dyna Super Glide
...2 week's. do you have a video for the change out procedure? I was told the compensator nut is a reverse thread. and what is the torque setting? No, it's the CLUTCH HUB NUT that has a left hand ...
...torque specs for screaming eagle adjustable pushrods for 99 Evo Factory Evo lifters have a range of adjustment/compensation of a little over .200 of an inch. Your aim is to set the pushrods to run in ...
Question about 2000 FXST Softail Standard
...torque wrench with a 1/2 inch drive head and an axle torque adapter such as (HD-47925) which simplifies the belt adjustment procedure by allowing the cone nut to be properly tightened without having ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions