...torque settings for the head bolts are on the bpt motor On a mazda gtx (4x4 turbo) 1840cc oil bolts and tighten in 3 even stages 30 ft lbs or 60nm 40 ft lbs or 70nm 60 ft lbs or 81nm torque sequence ...
...twin cams. thanks. Remember you have pre loaded cam gear's that have to be loaded, or it will make kinda of a lifter noise but not lifter's. Torque step #1 17-19 ft.lbs step #2 additional 85-95 ...
torque settings 2.0L 4 cylinder cylinder head bolt torque step 1 13-16 ft lbs. step 2 additional 85 degrees step 3 additinoal 85 degrees 2.5L V6 head bolt torque step 1 17-19 ft lbs. step 2 additinoal
looking for head torque settings for millenia 2001 2.5 L engine cylinder head bolts step 1 17-19 ft lbs. step 2 additinoal 85-95 degrees step 3 additinoal 85-90 degrees
...down - settings Here is a picture of torque pattern for a 2200 2.2L Tighten the cylinder head bolts in 2-3 steps in the proper sequence. The final torque specification is 59-64 ft. lbs. (80-86
the cylinder head. 3. Lubricate the bolt threads and seat surfaces with clean engine oil and install them. Torque the bolts in 2-3 steps to 56-60 ft. lbs. (75-81 Nm) in the proper sequence. Hope helps
...torque setting for the crankshaft bolt on a 1997 Mazda B6 8valve carburettor engine and also for th water pump bolts? What motor....L 4-218cc 2.2L 2200 2-bbl L4-218cc 2.2L 2200 MFI or L4-2606cc 2.6L ...
...be a maximum deflection of .37" to .45 " ( 3/8 to just under 1/2") with a 22 lbs load applied on the belt . the tensioner pulley is then tightened up at the pulley nut to 28 -38ft lbs torque ...
...2. If the fluid shows indication of slippage, recommend transmission replacement or overhaul. 3. If the fluid looks to be in good condition, suggest replacement of the Torque Converter Clutch (TCC) ...
torque settings mazda 2 1500 zy moter Check this manual for the specs. http://www.championbrands.com/aera-torquespecs.pdf
Usually answered in minutes!
738 Questions
692 Questions
544 Questions
609 Questions
615 Questions