...torque tighten !!! SETTING WHEEL BEARING CLEARANCE : 1. Wheel bearing play is correct when the thrust washer can just be moved using a screwdriver simply by applying pressure, without having to apply ...
2. Remove top and bottom caps (on back side of the caliper) for access to guide pins, then unbolt and remove them from the brake carrier. Remove the caliper. 3. Now you must thoroughly clean the brake
...2,25 liters - Specification: Gear oil SAE 75 W 90 (synthetic oil) Part number G 052 145 S2 (1 liter) - To check oil level, unscrew oil filler plug placed on the left side of the gearbox in front and ...
2. Remove top and bottom caps (on back side of the caliper) for access to guide pins, then unbolt and remove them from the brake carrier. Remove the caliper. 3. Now you must thoroughly clean the brake
2. Remove top and bottom caps (on back side of the caliper) for access to guide pins, then unbolt and remove them from the brake carrier. Remove the caliper. 3. Now you must thoroughly clean the brake
...torque setting for the rear wheel bearing 2000 audi a4 FWD? New bolts ; 1. tighten 190 Nm with wheel off the ground. 2. lower car to ground, tighten further 180 degrees 3. tighten further 90
...torque settings for the cylinder head on an audi a4 1.6 1998. Cylinder head instructions for Audi A4 1.6 (1998) Tightening sequence: Renew cylinder head bolts: Yes Stage 1 - Tighten: 40 Nm Stage 2 - ...
torque settings for the cylinder head on an audi a4 1.8 1997 petrol Cylinder head instructions for Audi A4 1.8 (1997) Tightening sequence: Renew cylinder head bolts: Yes Stage 1 - Tighten: 40 Nm Stage
...(Pumpe Duse) Cylinder head tightening sequence: Renew bolts! Torque settings: 1. Stage 1 = 40 Nm 2. Stage 2 = 60 Nm 3. Stage 3 = 90 Degrees 4. Stage 4 = 90 Degrees Please do rate my response.
Usually answered in minutes!
786 Questions
747 Questions
638 Questions
616 Questions
604 Questions