Questions & Answers for: Harley Davidson XL 1200 C Sportster Custom torque settings 2 4

2 years then problem started, had bike dyno'ed 75bh 74 ft pounds torque. ran great for some time. then gradually developed probs, had bike tuned , changed plugs, plug leads, cleaned carb, tempory fix,

2, 3, & 4 in the drawings, not literally. The front head bolts are numbered differently from the rear as well. You torque the bolts in three steps. The first step, you torque the bolts to 7-9 foot

rear axel torque and rear brake cylinder torque Rear axle torque is 60-65 ftlbs.

torque. 2, Tighten each bolt to 12-14 foot pounds of torque. 3. Mark each head bolt and head with aligning marks. Tighten each bolt 1/4 turn (90 degrees). Cylinder Head Bolt Installation Torque Wrench

what is the correct torque setting for rear axle nut on 2007 sportster[1 inch axle dia] sorry i do not know,,,check here http://www.hdtalking.net/

...Eric, remove the fender strut holding the turn signal then remove the turn signal support arm and torque the turn signal to the arm to 10 ft lbs. then install the support arm/turn signal assembly

...repair or up grade information you'll need. You'll be needing all of the specs like the Ft. Lbs of torque as well as the sequence of the bolt pattern. One thing that might be helpful: Do not torque ...

rear sprocket torque specs Hi Anonymous, 1. Laced wheels 45 to 55 ft lbs. 2. Cast wheels 55 to 65 ft lbs. Have nice day.

torque settings 1996 harly davidson front sprocket Hi Cloyd, 115 ft lbs. Have nice day.

exhuast stud torque setting Be careful,you dont want to over tighten and break studs ,just use lock washer and snug up,thats all,done lots of exhaust changes on my 94 Wide Glide quite easy,take care.