What size torx socket do I need to take caliper off? I have a 2001 GMC Sierra 1500 pickup I want to change brake pads and wondered what size torx socket I would need? Thank You. most likely a t50
...not an interchangable bit in a holder. You can get a T10 screwdriver at sears for about $5. You can also get the Kobalt folding Torx set (with Torx sizes from 9 to 40) for about $10 at
what size torx is needed to remove the front brake caliper on a 2005 dodge durango Hi, It requires a special size that comes as a socket type from the parts store. I believe is is a TORX 45. But, ...
Question about iPod nano 5th Generation
opening a Toshiba MK8010GAH drive case - what size Torx bit? Trying to determine what size Torx bit is required for the Torx screws used for the case of the Toshiba MK80110GAH. A T4 is too small and a
...off throttle body of 2006 Suzuki forenza? How many points are on the bit and what size is it? its a Torx bit? if it is any torx bit kit has that size. its not for security, its for fast , ...
Question about 1997 Grand Cherokee
...torx kit has all sizes, one can need. with no sets. you must measure them. it's not covered in the FSM. only 175ft/lbs on the axle nut and need for a torque wrench that big. kit ...
Question about 2003 XJR 1300
...xjr 1300 Good question! I have not had to remove my ohlins as yet and do not know what size the torx key would be. I think it is a torx ...
Question about 2006 E350
What is the torx size head for removing the rear tail light assembly? I need to remove the four screws that hold on the rear tail lights. What is the torx driver size? Star set T-20 should fit It's ...
Question about DC35 Handheld Vacuum
What size Torx screwdriver do I need to fix a Dyson DC35? There is a clog in the neck part of the vacuum head. There are 4 Torx screws but I don't know what size Torx screwdriver to use. Any help ...
Question about XL® Classic Bagged Upright Vacuum
So I can remove the motor and purchase the correct driver, what type and size torx screw does it use? Fran, If I remember correctly, I believe you need a #20 Torx bit to remove and re-install those ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions