...Unit lifts up. If the unit does not lift it is latched correctly. Re-install the Imaging Units and Toner (Dry Ink) Cartridges. Lower the Top Cover. Dispose of the old Transfer Unit as normal ...
...cover (the one that gives access to the Transfer Belt and Drum. Make sure the Drum unit is properly pushed into the printer, and that the Transfer Belt is lacated properly AND the two locking levers ...
Question about MFC-9420CN All-In-One Laser Printer
MFC 9420cn is asking for a transfer roller?... Where do I look for the transfer roller? Open the back cover near the top. The transfer roller is part of the cover that you open.
...transfer belt ending. why? If memory serves me right, after you replace the belt, you power machine on, wait for the error message, open the cover then close it. It should re-initialize the new belt. ...
...cover of the machine. 3 Release the transfer roller lock levers on the right and left-hand sides, and then lift the levers to release the transfer roller. 4 Take out the transfer roller by gently ...
...Transfer Roller " cover it should be that roller that seen when open the front cover most likely the Bias transfer roller door sensor in NOT detecting the dorr closed. make sure the tab isn't broken ...
...one and still won't print and still saying to replace the transfer belt. Is there are reset process? open the top cover press and hold the main button wait for the 3 lights to go up, release and ...
TRANSFER COVER ), you will see two handles, left and right of the drum ( green roller ), grab them and pull the drum unit out. Reinsert new drum unit, put back the transfer cover, lock the blue handle
Question about ImageRunner 1600 Copier
vacum cleaner the copier inside.Open the right cover and remove 2 srews,remove the transfer belt unit and clean the transfer belt cleaning blade and the transfer roller unit located on the right cover
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions