Question about 2000 Trooper
...gear change intermittently the transmission indicator starts moving between P, N, D, 2, 1 without any pattern and the transmission "KLUNKS" in the lower gears. trans nuetral saftey swich needs ...
transmission wont shift into any gear if you can shift gears with car off might be the clutch or slave cylinder. If you can start the car in gear,clutch pushed in and doesnt try take off probally not ...
...gear and move, occasionally i can get it to but it skips pretty bad and doesnt want to switch gears, sometimes it clears out and runs great shifts gears well and everything but then will just rev up ...
...transmission maybe. Try going into a lower gear (2 or 1) and giving it a little gas and holding it there. (about 2500 rpm) Hold it there for about 30 seconds. If it still doesnt move, look under at ...
...gear on reverse, it doesnt move nor respond. But it moves slowly when its on drive and move good when on 1 and 2 PROBLEM WITH TRANSMISSION. Check the ATF level. if low add fluid. if fluid level ok, ...
gear and its an automatic! Check the transmission fluid level if it is ok check if vehicle will move in any other gear reverse 1 or L etc. If not it maybe a torque converter issue and maybe best for a
Question about 2005 Altima
...gear after changing transmission fluids. Slow to pick up gear engagement Did you flash transmission,could be the problem!!! You probably didn't add enough fluid. Check in neutral with engine
Question about 2005 Altima
...it in 1st gear. When in 1st car shakes and doesnt want to move There is an internal transmission failure. Recommend taking the vehicle by tow truck to a trusted transmission specialty repair
Question about 2008 Impala LT
gear facing upward. Chevrolet Impala Transmission Problems - Car Forums at Edmunds.com forums.edmunds.com > Chevrolet > Chevrolet Impala Aug 9, 2009 - 30 posts - ?19 authors Learn more about Chevrolet
Question about 2008 Impala LT
TRANSMISSION DIED , TRIED EVERY GEAR NOTHING MOVING THE CAR START NORMALY AND I CAN SHIFT IN ANY GEAR SMOOTHLY BUT CAR DOESNT MOVE run the fault code look for a problem torque converter servo/solenoid
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions