Questions & Answers for: transporting air conditioner its side Freezers

air flow is good. Also, When you transported the unit did you move it standing vertically like it normally stands or did you lay it on its side. If you transported the unit on its side you must wait a

...side down - it was laid down on it's back when transported). When I plugged it in, it worked wonderfully for about 20 hours or so, and then my GFCI circuit was tripped. If I reset the GFCI, the light ...

...transporting it to my place I waited 24 hours and plugged it in. It did not run but did make a slight buzzing noise for 5-10 seconds before the overload sensor tripped off. Tried again a few minutes ...

I bought a used Kenmore upright freezer, it's been on for over 24 hrs, and it freezeswell, BUT won't turn off. Runs alllll the time. Any suggestions?? Did you transport it STANDING or LYING down? If ...

transporting but was transported laying down on its side. I was told that the freon may have leaked out because of it being laid on its side, is this the reason its not freezing? If so, how hard is it

My amana upright freezer was working fine, but transported it to another location when I plugged it back in, it started to make a buzzing noise. How do I turn this off or fix it? Hello....First...when

Can this freezer be laid on it's side or back to transport? Thank you. Lay down a shipping blanket or an old blanket and transport the freezer on it's back. It can be transported laying down, but ...

CAn we transport a 5 cu. ft. Arctic King Freezer on it's side? Not really, their is oil in the compressor. If you place on its side, this oil will drain out of the compressor. When you set it upright ...

...side for moving only if you have no other choice. When transporting a freezer, keep it in an upright position. If transporting it in an upright position is not possible, lay it down on the compressor ...

can I transport for 3.5 chest freezer on its side for 15 min? Will this short time damage my freezer and how long should I wait before plugging it in The issue is the oil in the unit that is part of ...