Questions & Answers for: Bosch trigger is stuck

...stuck by debris, and does not fall down to its inactive position, it can prevent water from filling. make sure there is no debris,and move the floater up and down until it falls down in its normal ...

...stem is stuck holding steem, guess you are talking about the shaft that holds blade. move the shaft down by squeezing the trigger.if shaft doesnt move you have a trigger problem or motor

...center) that pushes into a sensor when closed. That sensor isn't being pushed in enough to be triggered. We just cut a bit of felt furniture padding and stuck in on the sensor so it would get ...

my Bosch rs20 reciprocation saw at stuck open and is locked. I am unable to turn the locking mechanism. thanks for help You have to press the blade into place to trigger it to close.

...trigger if the fan is already on. Just can't get the fan to NOT come on when the power is turned back on! So we still don't have hot water. my guess is that the fan needs to be reset or something?? ...

trigger I hear the compressed air but the hammer does not come down and drive the nail. Usually when you hear the pop of the compressed air and the driver does not move indicates that the driver blade

stuck. Thanks If the bits get a bit distorted they will stick, if you have a bench vise clamp the bit in the jaws and give the trigger a quick pull.(reverse) That should dislodge the bit. This happens

...center) that pushes into a sensor when closed. That sensor isn't being pushed in enough to be triggered. We just cut a bit of felt furniture padding and stuck in on the sensor so it would get ...