...you have tried this but use a lubricant on the trigger if that doesnt work try unscrewing the case and inspecting the trigger inside for broken or stuck parts you mayneed to buy a new trigger ...
Question about Ingersoll Rand Air Tools & Compressors
ir2135ti runs when hooked up,in either direction sounds like the trigger is stuck internally
Question about 1/2" Super-Duty Impact Wrench (ThunderGun) - 232TGSL
...trigger YOU MIGHT HAVE A PROBLEM WITH THE THROTTLE VALVE SEAL ITEM #3 (O-RING) OR A STUCK THROTTLE VALVE PLUNGER ITEM# 5. TO ACCESS THESE PARTS YOU WILL NEED TO REMOVE THE INLET BUSHING ITEM# 6. ...
Question about 1/2" Super Duty Air Impact Wrench
...stuck trigger condition. Remove the air strainer assembly (item # 10), followed by the spring (item # 8) then the throttle valve (item # 6) you will see the throttle valve stem (item # 9) spray some ...
Wrench runs continuously when I puy air supply to it. I checked the trigger pin and it seems to be fine. What else could it be? Thanks The inlet valve must be stuck open
Question about Ingersoll - Rand IR125 Needle Scaler
trigger it just blows air out of the lower body of the gunAddiwhng details will get you a faster solution from experts the valve inside is stuck try putting some oil in it over night if still no
STUCK TRIGGER USING IMPACT TAKING OFF TIRES TRIGGER STUCK IN ON POSITION BUT STOPPED WORKING, DISCONNECTED AIR, PULLED OUT TRIGGER WITH NEEDLE NOSE PLIERS. CONNECTED AIR AND GUN WORKED THEN STOPPED ...
Usually answered in minutes!
14 Questions
10 Questions
14 Questions