Question about PC0974 Finish Pro 10 23 Gauge Pinner Compressor Combo Kit
stuck down, try to push it up. Will it move? If there are no problems visible at this point you will have to open the tool up, and see if anything looks out of place. To examine the inside of the tool
Question about FP620 Framepro 602 2" - 3 - 1/2" Full Round Head Nailer
trigger and drive a nail in, the metal rod that drives the nail in gets stuck and doesn't retract back into the gun. I can push the rod back up into the gun and then fire the next nail. I tried oiling
Question about FP620 Framepro 602 2" - 3 - 1/2" Full Round Head Nailer
...trigger is stuck. You need an o-ring repair kit. As there are a few different versions of the FP600 I don't know which one you need. If you go to www.senco.com and click on the nailers, staplers and ...
Question about FP620 Framepro 602 2" - 3 - 1/2" Full Round Head Nailer
...trigger is pulled and will not shoot the nails. Sounds like the bar that slides down to push the nail is jamed you should disconect it from the air and check to make sure a nail is not stuck you ...
...trigger could be a jammed nail in the nose/magazine area or a driver problem. is the driver fully retracted or stuck partially down in the nose. UNPLUG the air before checking. If the driver is ...
Question about FP620 Framepro 602 2" - 3 - 1/2" Full Round Head Nailer
I have a Senco FramePro 601 that will not discharge a nail when I pull the trigger. Air discahrges at the top of the nailer when I pull the trigger? Do you know what could be thr problem? Thank you. ...
Usually answered in minutes!
9 Questions
7 Questions