Questions & Answers for: trim on trunk

trunk panel trim. 1. Remove the license place from the DeVille rear trunk panel. 2. Remove the 4 bolts located below the license plate. 3. Remove the trunk panel (felt) trim inside the trunk. 4. There

Ad

...trunk lid trim on 1968 mustang? A lot of brackets and only a couple of nuts. Any idea? I don't have any pre-drilled holes either. the two nuts go at the end of the trim two bolts sticking out of the ...

Ad

...trim panels within your trunk. There are typically two cargo hooks that screw out found on either side of the trunk opening. Also, there are Christmas tree push pins found on the trim panels located ...

...trunk. The trim will be secured by some screws that should be along the perimeter of the trim. Once the screws are out, gently pop the trim off (there will be retaining clips that you don't want to ...

...Trunk trim as needed Nuts securing rear combination lamp assembly, from inside the trunk Connectors Combination lamp assembly To Install: Install or connect the following: Combination lamp assembly ...

Question about 2002 Jetta TDI

1 Answer

...trunk without damaging it. Any idea or help is greatly appreciated. Enrique . Crawl through the rear seats and remove the trim panel with a Philips screwdriver. Most likely the actuator rod has come ...

Question about 2002 Jetta TDI

1 Answer

...trunk trim and remove the plastic wing nut. I removed the 2 fasteners but not sure what it means by pulling back the trunk trim. The trunk trim would be plastic inside of car. Anything you can do to ...

trunk panel trim. 1. Remove the license place from the DeVille rear trunk panel. 2. Remove the 4 bolts located below the license plate. 3. Remove the trunk panel (felt) trim inside the trunk. 4. There

...trim inside the trunk and you can see them, a wire hook might reach it and hook it out. If you can't see it you will have to remove the trim and get it that way. The trim is usually held in place by ...

...door. Apply even pressure and avoid using excessive force to prevent any damage. Once all the fasteners are released, carefully lift the trim panel off the hatch/trunk door and set it

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...