Questions & Answers for: Ford Fusion turbo fault

ford fusion 1.4, 54 reg Hi, just recently put a new coil pack on my motor and now I keep getting a fault code up. The code is P0420, lambada/cat u/s. Took it for a big burn out and reset the codes, is

turbo fault i lost all power of my car and thought it was my turbo. i removed my turbo and noticed the propellor at the exhaust side was detached.what can cause this and should i look at anything else

...to the engine...will go about 55-60 by flooring the gas pedal. It jumps/shakes. Help!! Check the turbo and Turbo intake hose. I've got the same problem and it comes up with a broken turbo pipe ...

the emmission light in my ford fusion is on what is it the emmisssion light comes on to alert you to the fact that a fault has occured in the electronic engine and emmission control system, there are ...

...replaced on the ford fiesta and seems after the car is running flat not picking up speed and the turbo is running fine and injectors are working ok. any idea? make sure all the sensers are ...

brake system and abs warning lights are both on You need to check on all four wheels if there is any damage on the sensors, wire break in the sensor lines to the ABS unit or finally a fault of the ABS

08 FORD FUSION PROBLEMS ITS ON BUT HAS NO POWER , WITH AC OFF IT OK HelloThe engine and transmission in this cars drive train are fully electronically controlled by a computer called the PCM (Power ...

2008 for fusion engine light is on run fault codes to see which sensor/servo is not working and causing a fault that may damage the engine or gear box. Replace faulty units.

What is the reason behind an intermittent electrical fault and engine failure Car has had diagnostic test and everything was 100% perfect and advised to drive until it happens again. Not a good ...

THE FAULT CODE P2004 means what The code is for a inlet manifold air control actuator but Honda call it a frequency control valve it should be changed for free by the dealer if I'm not mistaken as its