...measurement is much more fine/accurate in that you are extending the rods to the front wheel and turning the rear axle adjusters 1/2 turn will see a big difference when extended 8' or so to the ...
Electrical Alarm No light at Alarm dead ignition, Lights and fuel pump do activate turning ignition, both remotes don't work my Manuel is not with me. TSSM or Turn Signal Security Module is more than ...
but wouldn't fire. Now with a charged battery the bike will just click, lights come on but will not turn over Put a jumper cable on your battery, i suspect your battery is really not charging. I had a
Question about 2005 FXSTD - FXSTDI Softail Deuce
want to change rear turn signals to dual fiament want to change rear turn signals to dual filament like front signals This is a pretty complicated conversion requiring a lot of additional wire and new
...knob end. The assembly is made of plastic and breaks easily. To adjust the tension on the cable. turn the knurled ring just behind the choke knob. Good luck ...
Question about 2004 FXSTD - FXSTDI Softail Deuce
...@ Hi, Cowboy376787 and the usual suspects are: 1. Contaminated or faulty speed sensor. 2. Faulty turn signal module. 3. Corroded, broken or loose connector pins/sockets in the wire harness between ...
Question about 2004 FXSTD - FXSTDI Softail Deuce
...a bad battery? @ Starter just has a clicking sound when trying to start. The engine never really turns. Thought it could be the bad battery (less than a year old), but charged overnight and ...
Question about 2004 FXSTD - FXSTDI Softail Deuce
...spins @ my 2003 softail deuce fxstd wont start it is pushing jack shaft out like it should but not turninig the fly wheel when it slides into place? Is it the starter itself or is there something ...
...gonna be excess oil inside that you will not drain. Add 2 1/2 quarts, let the engine idle, then turn off your engine and set the bike level to check where the fluid is on the stick. Dry the stick ...
Question about 2005 FXSTD - FXSTDI Softail Deuce
2005 harley deuce left turn signal flashing when ignition turned on when i turn the ignition switch on the left turn signal starts to flash. it will not turn off by pushing the left turn signal button
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions