Questions & Answers for: turn signal 1989 250

turn signals but this one fuse causues alot of problems. Sometimes this fuses isnt marked on your cover so you might have to look in the maual to find the right fuse . some will be under the hood some

I Have an 03 zx7 I bought an undertail with intergrated turn signal but when I hook them up both blink at the same time. sounds like a bad earth, Try earthing one and see how that go,s

turn signal extenders (rubber pieces) are cracked and wanted to replace them. I don't have the manual yet and can't find the part number and don't know how to find the parts...........help me please!!

...turn signal lever. Remove the column trim shrouds. Unbolt the steering column and lower it carefully. Remove the ignition switch and warning buzzer and pin the switch in the LOCK position. Remove the ...

...i cross over relay replaced relay still wont run untill fuel relay is crossed over The relay is turned on by a "pip" signal from the ignition module. Take your module to the parts store for ...

...1989 chevy 3/4 ton pu with a 350 motor. It reads 230-250 on the heat gauge. I had replaced both heat sencors on the side and the top of the block. Has a 180 theromstat fail safe. When it reads a high ...

i have a 89 f250 i have no turn signals , brake lights or hazards..i do have turn signals and running lights on the front the rear wiring harness for the lights at the bed and bumper are either ...

I have no turn signals The trafficator can maybe faulty.To test this, press the hazard switch and if all the indicator lights do not blink then it confirms the trafficator can is faulty and needs to ...

location of turn signal flasher F-250 1989 I believe it's under the dash above the fuse box. It's a small round plug in deal. It may be square as well, but it should say flasher on it. Hope this helps