Firing order in 1500cc motor how do I set up the spark plug wires to the distributor #1 plug is closest to the front. Take off distributor cap. Remove #1 plug. You want to crank engine until #1 ...
Question about MG
i bought a mgf vvc off a friend and she sed the head gasket had gone so i replaced gasket and had head skimed and put it all back togeather again but car try's to start but thats it it has spark b
Question about MG
turn signals will not blink when turned on, the front turn signals do work when turned on 1977 mg midget turn signals on borh sides will not blink when the turn signal is on but the front signals work
...lock is a spring loaded peg, which is drawn out of a slot in the steering column when the key is turned. The spring holds the peg against the column and then pushes the peg into the slot when they ...
Question about 1964 B
fuse keeps blowing 1964 mgb no taillights signals brake lights or speedo or tach See summary above You have a short in the wiring harness. I would start by looking in the trunk only because that is ...
Question about 2004 TF 160
...driving and even my speedometer went off and my steering became hard to work. when i stopped and turned the key off it would not turn over and now there is a very loud clicking sound could you ...
my mg zr has no spark 1.8vvc160 tuns over hi I brought a 2001 mg zr 160 , suspected head gasket which I did, can turns over by hand tried to start car with key it turns over but there is no spark, I ...
Question about 2004 TF 160
Why does my MG ZT two litre diesel show low oil pressure and cuts out? The engine is designed to cut out after a few seconds without oil pressure. So you need to establish if it's a faulty signal, or ...
Question about 2004 TF 160
Is the horn switch on a 1976 MG Midget on the turn signal switch? Yes. 68-70 horn is on the turn signal. 71-77 it's located at the center of the steering wheel. 78-79 on turn signal again. It's ...
...marks on the crank pulley. Is there an easy way to find TDC for No. 1 ? What is the best way to turn the engine over by hand both with and without sparkplugs installed ? I use a large socket on ...
Usually answered in minutes!
9 Questions
3 Questions
3 Questions
3 Questions
4 Questions