Questions & Answers for: Chevrolet Equinox turn signals

Turn signal won't go back to "Off" by itself. When i make a turn and i use my turn signal it stays on after i make the turn. It should normally click back to the middle but instead it stays on like im

...turn signals.  It uses one of those new-fangled things called a computer, which uses solid-state drivers to operate the turn signal bulbs.  Therefore the "clicking" that was produced by the ...

turn signals and hazard lamps. When the turn signal switch is placed in either the left turn or right turn position, the BCM receives a signal from the turn signal switch. The BCM then sends an on-off

right rear works on emergency flashers. Turn signals do not work. on the rear.I opened the fuse box up and replaced relay #66, but it didn't help. It sounds like the flasher is underneath. blown blub

Left turn signal quit. Then Dash lights went out. Left turn signal quit. Then Dash lights went out and the turn signal worked again. What do I need to do? can be loose wires

...turn signals? turn signals do not work new fuse block new battery new turnsignal switch new flasher New light bulbs? That turn signal switch that goes on that circuit board behind the fuses may have ...

...on the passenger's side of the instrument panel. Turn and hazzards are in this fuse box. If no turn signals, it may be a bad flasher unit or relay. Good-Day! The relays are in under hood fuse

...top,but the regular brake lights dont As in the previous comments the brake switch wire goes to the turn signal switch and the third brake light. Since the 3rd brake light is working, the problem is ...

turn signals and hazard lamps. When the turn signal switch is placed in either the left turn or right turn position, the BCM receives a signal from the turn signal switch. The BCM then sends an on-off

No left turn signal. Light. Front and back No turn signal light on left side Fuse 14 a 10 amp fuse in the underhood fuse block feeds the left side lights. Are the parking lights working on that side ?