Question about 1986 Ranger 2WD
2001 Ford Ranger right turn signal doesn't work when the braking When I have the right turn signal on and apply the brakes the turn signal lights stop flashing and stay on until I take my foot off the
Turn signal problem On a 1993 Ford Ranger 2wd, I have a left turn signal problem. I have changed bulbs and flasher with no improvement. When left signal is selected (headlights off), I get flashing ...
I have a 1998 Ford Ranger. The right turn signal I have a 1998 Ford Ranger. The right turn signal does not work. If I hold it in the position, without going all the way, the signal goes on, so I don't
Turn signals not working.All bulbs are good,no fuses blown.The emergency flasher works on all four lights.Replaced the turn signal switch.Could there be relay somewhere? The emergency flasher and the ...
...if the fuse is found good, replace the turn signal flasher. I am assuming when you state the blinkers are not working that both the front and rear turn signals are not lighting at all. Good
...try to start it. I had a truck that did that and it messed up my turn signals until I brought the key switch back a little after starting it. Just a simple idea. Be kind with your rating for me. ...
right back turn signal fuse for ford ranger 2005 where is it what number is it and what voltage is it I don't think that there is a fuse for one turn signal light, if the fuse for the turn signal ...
Question about 2001 Ranger Regular Cab
...turn signals. Left is fine. changed turn tignal bulbs front and rear was the correct bulb used? this sounds like a single function bulb was used NOT the bulb that will light with the headlights and ...
...turn signals 1994 Ford Ranger 2.3 engine flasher works. both turn signals quit at same time Diane, There are 2 separate flashers on your vehicle, one is for the emergency/4 way lights and one flasher ...
Question about 1994 Ranger Supercab
...the 91 used a separate fuse for turn signals. There's one for four way flashers and another for turn signals. I think it's fuse #5 on most diagrams, a 15 amp fuse. Give that a try and good
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions
