Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
...valve actuators one on the suction side and one on the return side go there and see wich vave still on spa mode this actuator needs to be replaced also check your control inside your house make sure ...
Question about Aqualink Rs4 One Touch Control System Control System
...actuator you will see a set nut on the center of the shaft that you use to set where the valve stops. If this is tight then you may have a bad micro switch in the unit and you should replace the ...
Question about Aqualink Rs4 One Touch Control System Control System
...valve actuator ( the motor assembly that turns the valve). Open up the actuator case and switch the valve to the direction it does work. You will see the microswitch that does work. Now, reverse the ...
Question about Aqualink Rs4 One Touch Control System Control System
...valve in a position to turn off what I believe is both the skimmer and main drains. Open the spa drain, and close the main return to the pool. However, when i do this the spa still overflows into the ...
Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
...programs for the spa. Double check this. I assume this is a pool/spa combination. If so, check the valve actuators at the pool equipment. Do this by manually turning on the pool with your Remote ...
Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
...valve actuator. When you switch to the spa mode the suction valve should should move to fully block pool drains. The return valve should fully block the pipes to the pool returns and spa fountain. If ...
Question about Aqualink Rs4 One Touch Control System Control System
valves do not actuate from panel but do with switch on valve make sure valves are activated go into system set up go to jvas then assign in and out make sure you have a pool and spa combo bezel board
Question about Aqualink Rs4 One Touch Control System Control System
...valve actuator has malfunctioned and did not move into the spa return position. Most actuators have a toggle switch on them where you can over ride the system. The 3 positions are; normal, off, and ...
Question about LAARS VALVE, PRESSURE RELIEF 75PSI 3/4" NPT
...valve actuator on the suction side is either bad or the toggle switch on the back is in the wrong position. There are 3 positions for the switch on/off/on. It should be in either be all the way up or ...
Question about Aqualink Rs4 One Touch Control System Control System
valve actuator on the suction side. Look at the main filter pump, then follow the pipe going into the front of it to that actuator. Theres usually a switch on it, the switch may be in the off position
Usually answered in minutes!
193 Questions
170 Questions
177 Questions
72 Questions