Questions & Answers for: Ford Explorer valve actuator

...valve. The ticking sound is the actuator trying to open the gate or the valve. I had this problem on my 03 ford. It was the blend door actuator. its a small thin white rectangular piece with gears ...

...mode door actuator, some models are supply by air solenoid valve, if you want to see the location of mtor actuator, this is on the left side of evaporator case, a little bit upper of accelerator ...

...to access it but that is what I would inspect first. If okay then I would look at heatr control ...

...actuator still no heat Hello prieto725 Check the vacum supply to the heater control valve, under the hood on the right side in line with the input heater hose. Have a helper move the temperature ...

...ends and in between for leaks or poor connections. If no vacuum leaks, remove the idle air control valve (see picture below). Clean the valve and passages in the throttle body using carb cleaner. ...

actuator is connected to. It is located behind the glove box. your shut off tap for your heater core is probably not working check the cable on the back of your control nob on the dash if the cable is

...actuator valve controls the fluid flow from the reservoir into the working chamber. Once viscous fluid is in the working chamber, shearing of the fluid results in fan rotation. The cooling fan clutch ...

1996 ford explorer no heat heater control valve replaced and thermostat air is blowing cold it switches to defrost and floor with no problem there is a valve on the heater hose under the hood. its ...

...actuator consists of throttle control motor, throttle position sensor, etc. The throttle position sensor responds to the throttle valve movement. The throttle position sensor has the two sensors. ...

actuator control circuit poor electrical connection P0401 Ford - Exhaust Gas Recirculation Flow Insufficient Detected Possible causes - EGR passage clogged - Faulty EGR Vacuum Modulator Valve - Faulty