...to be replaced, It works off a vacuum tube off cyl 2 and once vacuum is established, it opens the valve-- hence you don't have to turn the valve to "off" to prevent fuel from seeping into the carbs ...
1985 yamaha Maxim 700 carbs gummed up. I went through the carbs but left them on the rack. Should I have taken them off and cleaned the stuff in between also? The tank is terrible! Somebody didn't ...
system is only charging at 13.8v max instead of 14.2~14.8v, There is some corrosion inside the wires and many of the wire plugs have corrosion. Would this bit of corrosion inside the wires have enough
Question about 1985 XJ 700 X Maxim
...due to faulty MAP, CKP, or CMP sensor. 5. Carburetor jetted too lean. 6. Leaking intake or exhaust valve. 7. Water coolant old or low change every two years. 8. Water pump failure. 9. Radiator ...
point setting for 1977 yamana sx750 I love those triples! I had a red one with a set of bags and fairing from yamaha back in the 90`s and it was a great bike-the valves needed to be shimmed every 20k ...
...at all times, even when the engine isn't running. When you combine that leak with a leaky float valve, the result is usually a crankcase full of gasoline - clearly not good. If you'd like to know ...
how to set valves my email is [email protected] thanks i have had two of these bikes before,and had one set at macleans sports in fredericton. they set them to tight and burned them up. so ...
...from it - the smaller of the two is not a fuel line - it's the vacuum line to trigger the petcock valve and it connects on the hose ****** at the top of the #2 intake manifold. Some people have ...
Question about 1985 XJ 700 X Maxim
...bad coils, corroded caps, leaking throttle shaft seals, restricted fuel, wrong float levels, bad valve clearance, bad compression, etc etc etc) but most often the ridability of an XJ comes down to ...
Usually answered in minutes!
652 Questions
453 Questions
469 Questions
316 Questions
292 Questions