Questions & Answers for: Rinnai vent blockage

in diameter. Remove it from the vent and see if the unit ignites. If it does, this indicates blockage in the outer vent passage. If not, you may need to contact a technician to investigate your issue

...hard to see. If there is flame but it goes out quickly, you have a blockage in the unit. Check the venting to make sure it is clear of

The Rinnai on demand water heater we just installed keeps shutting off then leaving a error message #10 on the display. vent blockage, bad fan, wrong DIP switch setting

...a way of cleaning it incase there is a blockage? Any suggestions would be very appreciated. Thanks Shane I would call him back out. It sounds like a gas line is loose or the vent is not on ...

...blockage in the vent or a slow combustion blower. If it still gives you an error code, Inspect the combustion chamber for cob webs or debris. You can access the chamber by carefully pulling the flame ...

...Blockage Ensure Rinnai approved venting materials are being used. Check that nothing is blocking the flue inlet or exhaust. Check all vent components for proper connections. Ensure vent length is ...

e-14 code mpi monitor 2400 heater runs for 10 minutes to 4 hours then shuts down with e-14 code. cleaned fan blades, didn't seem to help. seems clean inside otherwise. It sounds like you have ...

...vent wall furnace is giving me error code 99. it won't light up.? Mfr Manual says of the error code 99: Flue Block Check around the flue terminal for blockage. I checked and there is no blockage. So ...

...vent apart and there is no blockage. Unit has only been installed one month. If it is only one month old doesn't do anything but call for warranty serving. ANY attempt to repair this will void the ...

...your system on and off to see if the Rinnaifault code 10 has disappeared. If it hasn't, check the vent system for blockages and other issues that could prevent