Question about Vision Fitness T9500 Treadmill
...most often used functions you just worn them out you can call vision fitness they will ask the upper console model and serial # (located on the back end of the console ) Here is their # ...
runs okay but is starting to make loud sharp clanking noises Clanking sound is bearing that has gone bad in a treadmill, unplug the treadmill remove the motor shroud. Use a long handled screwdriver ...
Question about Vision Fitness T9500 Treadmill
...Vision Fitness treadmilll #T9450. When I have the Vision Fitness treadmilll #T9450. When turned on the screen will light up and beep, but the belt won't move. It hasn't been used very much, but I've ...
Question about Vision Fitness T9500 Treadmill
...Vision T9500 Ortho and I use wax to lubricate the belt. It has about 150 hours and 650 miles of use on it. It is about 4 years old. have you removed and cleaned the wax buildup off the rear roller? ...
Some of the console overlay buttons stop responding. If I unscrew the console and remove all connections from the console board, and then re-connect them, the problem goes away temporarily. Sometimes ...
error lines in function area adjust the reed switch, see the diagram attached , clean, and tight the wires very well.RUN the software calibration for diagnose, and troubleshooting.If you can not run ...
error lines in function area Dear Sir:Adjust the reed switch, clean and tigh the connector very well, see the diagram attached2) tight the ribbon cable from keypad +tight connector from display board ...
error messages error lines Dear Sir:Adjust the reed swtich see the diagram attached, clean, and tight the connector very well.tight the ribbon cable from keypad, and connector for display board vs ...
Question about Vision Fitness T9500 Treadmill
When I press start on my T 1450 it appears that it immediately trips. what can be the problem see the video and fix it. However if after you lube the problem remain. replace the old board deck, and ...
...vision fitness 9250 treadmill stopped suddenly after I heard & felt a pop in the front under the cover. The elevation works along with all the display. The only thing not working is the motor to ...
Usually answered in minutes!
346 Questions
191 Questions
188 Questions
214 Questions
122 Questions