...the Sensor mmHg standard atmospheric pressure). Atmospheric Pressure Sensor (Service Code 15) Input Voltage Inspection NOTE o Be sure the battery is fully charged. o The inspection is the same as ...
...box, fuses are ok These bikes have a module that will not alow the starter to engage if the battery voltage is to low. You need to hook up a battery charger and ck the battery voltage. If battery ...
Question about 2008 Ninja 250R
...light works and it has correct bulb You need to remove the bulb and check to see if you are getting voltage to the socket when you hit either the front brake lever or rear brake pedal. Use a test ...
91 zx600 ninja voltage regulator i need to buy a voltage regulator and found som on e bay but i need to know what years are compatable they are all pretty close, check the plug shape and the different
...Need to check the charging, get a multi-meter (volt meter) and charge the battery and measure the voltage of the battery with the bike not running, then start the bike and rev it up to about 4000 ...
...your charge at the battery whith out the motor running it should read above 12 volts determine the voltage stored in the battery with the meter stil conected hit the start button if the meter shows
Question about 2001 KLX 300
Have 2001 Kawasaki Bayou 220. Low voltage at battery terminals. Have 2001 Kawasaki Bayou 220. Low voltage to battery (around 2 volts) when running. Battery has completely discharged from lack of ...
...same thing again and will not start up at all. There is no gas in the lines and I can't find any voltage at the fuel pump.There are 2 wires going to the fuel pump. There is a dead short between ...
...shaft. This turns with the engine, producing the AC charging power. This power then runs through a voltage regulator, that both converts the the AC voltage into DC voltage, and regulates the amount ...
Question about 1993 KLE 500
...way they will work is if i rev the engine can anyone help When you rev the engine, the alternator voltage increases. I think that the LED bulb does not light up, do to not enough voltage at lower ...
Usually answered in minutes!
239 Questions
197 Questions
175 Questions
157 Questions
126 Questions