Questions & Answers for: LG WM washer will not drain

...drain overflow hose. The washer has been working fine for a year and this problem just occured. The washer is obviously completely unusable in it's current condition. That drain hose in front has a ...

...drain My washer doesn't seem to drain and I'm getting a OE error. I have drained the tub from the front drain, and then it works, but it's not draining out the back. The LG customer service thinks it ...

...drain from the washer. 3(a) If the hose seems plugged and will not drain, it is most likely pulled out too far. Do NOT pull the hose until it is tight, leave some slack! 3(b) If the drain pan gets ...

remove and clean- back flush to see if this works. Also make sure that the level of the washer is tilted to the drain side valve as no water must remain but drain in gravity. use a spirit level to set

...washer through the drain hose but still can't get it to drain. Hi, Problems with a washing machine not spinning or not draining are often interrelated.. If you are having a problem with your top ...

...washer will not drain properly. The drain hose should not be installed more than 1 meter higher than the bottom of the washing machine. Confirm that the washer is leveled properly, if the unit is not ...

...to the washer.Another problem could be that your drain hose is too long and it is clogging up at the elbow of your drain line, if so cut of  a few inches at a time and try to drain washer ...

...drain-washer-not-draining-water/#ixzz3X2LbXMWJ The washing machinedrain hoseis where the water flows through to get the water out.If this drain hose is blocked, kinked, bent, or clogged, the washer ...

...drain Washer will not drain: Thedrain water pumpis the main part in your washing machine that pumps out the water. If this is defective or has failed in any way, this will be the reason why your ...

drain pump Washer reads OE which is kinked or clog tunes. I've cleared the tubes that didn't work, checked out and replaced the drain pump. That didn't work, checked that it was receiving power and it