...washer. Remove 3 shipping bolts, 3 yellow spacers and 3 metal "P" clamps from the back of the washer. Remove the access panel from the front of the unit and remove 2 yellow shipping braces and large ...
...adjusted ck to be sure shipping rod has been removed you will need to pull washer out and look for a pin through a rod that runs from 1 side to the other pull it completely out relevel washer if ...
...washer went off balance Check the Vibration damper rods to be sure that... 1. They are there and mount is solid. 2. If they are broken in 1/2. 3. The plastic knuckle mounts are not missing/broken. 4. ...
...washer. need help quick write back please Check the Vibration damper rods to be sure that... 1. They are there and mount is solid. 2. If they are broken in 1/2. 3. The plastic knuckle mounts are not ...
washer does not seem to be off balance. Who installed this? Sounds like they didnt remove the shipping rod located on back of machine. If so, refer to instruction manual for how to remove rod. Usually
Question about Elite 45986 Front Load Washer
...washer 3417-41142000 Check the Vibration damper rods to be sure that... 1. They are there and mount is solid. 2. If they are broken in 1/2. 3. The plastic knuckle mounts are not missing/broken. 4. ...
washer has 2 braces on the front of the drum to the frame that are broken. Are these necessary or used for shipping? They are 3/8 rods. Shipping pins. Just to secure the drum. Thanks for using FixYa -
Question about 44042 Front Load Washer
washer model # 100.24812200 Check the Vibration damper rods to be sure that... 1. They are there and mount is solid. 2. If they are broken in 1/2. 3. The plastic knuckle mounts are not missing/broken.
washer ofbalance Check the Vibration damper rods to be sure that... 1. They are there and mount is solid. 2. If they are broken in 1/2. 3. The plastic knuckle mounts are not missing/broken. 4. There ...
...washer bottom or hits on the shipping rod brackets. The two supports in back are individual parts, the front is one part which goes all the way accross the front top of the washer. Remove them and ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions