Questions & Answers for: Maax water heater

how do you set the maax crescendo tub water temp?? my tub will only get to 91 degrees... help That's as far the thermostat will go?Maybe it need calbriate. is there a special cleaning tool for this ...

infiniti hot tub reads HL I have a infiniti hot tub it will not heat I have replaced the pump it worked for a while now reads HL very cod plase help the pump just pumps, do you have a heater it would ...

...water heater be put on ? Water heater can be added to any incoming water line, either on hot or cold. http://waterheatertimer.org/How-to-install-under-counter-water-heater.html Under-counter water ...

...water heater is broken. Need source and part number for heater, and point of contact to repair and replace. If your bathtub heater is no longer working we need the model number off the old heater in ...

...heater does not heat the water it only maintains the water temperature that is in the bath. try filling the bath with the required water temperature and see if the heater maintains that temperature. ...

...water at the start for the heater to operate properly ? Is there a "trick" selecting the tubs settings which will allow the heater to heat ? Bath tub heaters will only maintain the water temperature ...

What is a requarement for motor, do we need it to be bonding ? Motor must be grounded with ground wire. Some local codes require outdoor motor shell to be bonded, with a ground rod driven into ground ...

...water heater may be limed shut. Heating water (especially 'hard' water) causes calcium to precipitate out and build up in the bottom of the tank which can cause poor recovery and if heavy enough, ...

...water in my spa when I discovered the heater element ... Is there a hose that should fit on it? ... I figure it will run similar to a whirlpool setup. ... tests on the unit...but, it sounds like 1. ...

...water heater often enough to prevent problems. Usually, draining it about every 6 months will do it. To drain the water heater, turn off the energy source (electricity or gas), turn off the inlet ...