Question about WCAM1812 Front Load Washer / Dryer
Asko WCAM1812 Front Load All-in-One Washer / Dryer It does not start the lights are blinking on spin. the door remains unlocked hold down the "cycle signal" button for 3-5 sec. unplug and plug back in
Question about WCAM1812 Front Load Washer / Dryer
i just realized i had been running my dryer with out cold water running through it and i just now put the water back on and my clothes still wont dry Maybe the heating element overheated and tripped ...
When I push the on/off button on -all the lights blink on and off and when I push the start button nothing happens. I tried to reset it by going to stop, but it doesn't help - I also tried unplugging ...
where is the lint trap? On the bottom right of the machine, with a coin trap door. Twist the knob left (on the inside of the door) and pull out towards you. Make sure you lay a towel down beneath your
Question about WCAM1812 Front Load Washer / Dryer
ASKO WCAM1812FRONT LOAD ALL-IN ONE RUBBER SEAL ON DOOR NEED TO BE REPLACED MY WASHER / DRYER IS LEAKING AS THE RUBBER SEAL ON THE FRONT DOOR HAS A VERY SMALL HOLE AND THAT RUBBER SEAL NEEDS TO BE ...
Asko WCAM1812 makes noise when draining the drain pump makes a loud grinding noise while draining, and clothes are wetter than normal after cycle completes. Usually have to do an extra spin cycle to ...
need to install a new on off switch http://www.repairclinic.com/Asko-Washer-Dryer-Combo-Parts?z=100
no power!!! plug in no power lights ...no power...but the door locks if you start pushing buttons HELP!!!!!! CHECK FOR A BLOWN FUSE IN PANEL>?
Question about WCAM1812 Front Load Washer / Dryer
it is taking 3 times at 160. they are light loads. I have cleaned the lint money catch out but I am also noticing that there is a lot of tint on the rubber on the inside. I need help! You need to have
Where can I get part? from a parts store .
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions