Question about 1993 Sentra 4 Door
1993 nissan sentra sparkplugs are getting wet car wont start i just had may gas tank drained and cleaned, had also my fuel pump replaced, the problem now, the car wont start and it's sparkplugs are ...
...are tight, spark plug wet with fuel. (New plug) Any suggeastions? that's the problem gas when wet won't burn remove the sparkplug and, dry it off with rubbing alcohol then reinstall prime and, ...
current running.Removed sparkplug and check if sparkplug are wet or dry, wet sparkplug signifies not functioning or no current at all this has to be replace. Check for the gasoline near the carburator
...on the sparkplug when starting; check that fuel is reaching the combustion chamber (sparkplug would be wet); check for engine compression. Postback results. Good luck and thank you for asking
...in the cylinder and on the sparkplug this will "dry out the engine" reassemble and, start the engine. It should start as a "wet with gasoline" sparkplug can not spark nor, will liquid gasoline ...
i had 92 honda civiv hatchback, the sparkplugs get wet with engine oil from vave cover, does sparkplugs has its own individual seals? The spark plugs, if getting wet from the engine oil dripping off ...
...does start and run a bit then your problem is fuel and not electrical. If it does not fire and the sparkplug is wet, then start be replacing the sparkplug with a new one. I did that and not geting ...
my sparkplug always wet with oil change sparkplug Outside would be bad valve cover gaskets. Inside would be bad rings. Rings are an engine rebuild.
Question about 125cc Full Size Adult 4 Wheelers ATV Quads
...wet sparkplug, but i check the gas ang sparkplug they were ok. I experience only this problem when its raining even a light rain. I apriciate your coments and help. Thanks! had an old bike the coil ...
Question about 125cc Full Size Adult 4 Wheelers ATV Quads
...wet sparkplug does not function, so the oven will n ot lit. As soon as the sparkplug is completely dry again all wil work again as it should. The second possibility is moisture in the burnernozzle, ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions