...350 wiring Where do the lines go from the battery to? Does the negative go to ground and the alternator? Where do the positive wires go? The way it is now it is not starting the negative wire on the ...
...wouldnt start and just blew like air through my throttle body on my 1990 chevy with 5.7 350 look at cap see what wire terminal upoint at thats #one on cap going clockwize,tothe left isfierining
...chevy 1500, 350 engine. putters after start 94 chevy 1500, 350 engine. putters after start up, and while braking, feels like its going to stall, and sometimes does. AFter it gets warm, it idles at ...
...wire and engine will not acclerate. This is a built 350 short block chevy with pro charger. 350 Chevy engine in what? 1990 Corvette? Who built it, did you? Sounds as though you have plug wires wrong. ...
...Chevy Z71 Vortec 350 i have a 1997 chevy Z71 and it will not start. all my fuses are working and so is my fuel pump. When i turn the key on none of my guage lights come on and when i crank it all it ...
installing a 350 chey, need to bypass neutral installing a 350 chevy, need to bypass neutral start switch Locate neutral switch, Put a jumper wire in place of the switch and your in buisness
Question about 1995-1997 Chevy 1500 Truck Ignition Starter Alarm Switch
...350, had trouble similiar, turned out to be a broken ground wire on back of engine towards firewall on passenger side. hard to work at and there are several grounds on it. mine went from top of block ...
Chevy 1500 350 shortbed l replaced spark plug and wires ,distributor cap and rotor button, ignition coil ,and modular under the distributor..and a new battery..the truck is just turning over and won't
Question about 1983 Chevy
350 engine. It does not want to start. I have a good battery and all my lights, wipers and indicators work when the key is engaged. The engine will even turn over fine, but it does not seem to want to
Question about 1984 Chevy
350 v8 c10, starter stud spins the one on starter for power wire You need to replace the starter solenoid. SHOULD BE A LOCK NUT ON INSIDE OF WIRE TO LOCK STUD STOP FROM TURNING SO YOU HAVE A NUT
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions