...50 start thing is nuts, after changing a battery you usually can drive it about a week and then they should be able to communicate with the computer...but nothing. This isn't a solution to your ...
...breaker block (b) the starter lead, and (c) a lead I added to the power amplifier of the audio system; when this occurred, I disconnected that last amplifier lead but that seemed not to make any ...
Question about 1997 Dakota
50 amp breaker goes to headlamps,, 50 amp goes to blower motor, switch those breakers around and problem is solved... check your connections @ lights, fuses, and altenator, and inspect the wiring. you
...50 .found the tab for the timing mark. is there supposed to be a mark on the pulley? Yes sometimes there's more then one, what I had to do is remove distributor cap and turn engine with a breaker bar ...
...50 2.0 L engine. My main timing belt was stripped. I replaced it and the secondary belt at the same time. When turning the crankshaft clockwise, the distributor rotor does not move. I have not yet ...
Question about 2004 Ram 1500
...breaker box. disconnect + battery terminal...1) Remove box and clean the large screw that connects to contact under box. it gets dirty and grease builds up...2) using ohm meter set on lowest scale ...
Question about 2004 Ram 1500
...50 , does anyone have the answer to where the wires go to the coil and resistor in the right order or a photo ? It's a four cylinder The wiring of an ignition coil is fairly straightforward as there ...
Usually answered in minutes!
2,271 Questions
2,049 Questions
1,788 Questions
1,616 Questions
1,496 Questions