Questions & Answers for: wire 50 breaker Motorcycles

...wire and a 40-50 amp breaker. Anything smaller will overheat and become a fire hazard, especially at 139 feet. You will need to pull # 6 copper for 50 amps of service,The stove does require 50 amps ...

...sure as to location of wiring, remove the switch and replace, reconnect wires, turn breaker back on,and you should be ready to go, This is assuming you have a 50 amp breaker in the electricial

50 amp. #6 wire. I just hooked up the same as I unhooked and changed the GFIC breaker in the "in the line sight box" outside. The breaker in the house was already 50 amp's.so no need to change that. I

...50 then a 2-60 is fine. I would run with a #6 copper wire, I would check with local code to verify the wire size in your area. Make sure that the unit is grounded as well. Minimum of a #10 wire, I ...

...50 amp. If that is not enough for your load, you must change the wiring. It also depends on the type of wire. THHN will have the largest amperage, but if it is TW, it will be lower. Rule of thumb ...

...Thanks. Is the wire compatable for a 50 amp breaker. Also unit souuld be on its own dedicated curcuit, also how many amps is the service in the building, if your only at 100 amp it will not

...50 amp breaker.The breaker size is on the model plate/sticker....any way the compressor is shot and it is time to find a new 3 ton condensing unit.espescially if it is TRIPPING a 50 amp.Good luck ...

...wire with 50 amp breaker.60 amp breaker x 80% = 48 amp safe maximum for 60 amp breaker. Again, use 6 gauge wire with 60 amp breaker.How to connect wires to unit.First of all, all outdoor HVAC units ...

i have a 50 ft. run from panel to dryer. what size breaker and wire do i need for my maytag neptune mde5500ayg You'll need at least a 4/3 wire and two 50 amp. breakers.

...50 amp breaker bike will run 4 10 min and stop and cool down and start again it is a 2003 i put a new 40 amp and it would do the same and i put a 50 and it does the same and it will crank but it will ...