Questions & Answers for: Pioneer how to wire a mixer

this with 2 mixers and both times it has the same results please can you help me i think i may have wired somethiong up wrong can you please help me with this kind regards Damian Byrne Try turning you

...wire up a pioneer efx 500 to my pioneer djm 500 mixer...i still want the effects to work for both cd players.thanks send out from mixer---------to pioneer in---------from pioneer out-----to return in ...

...wire slack catches. cut/snip the wires as close to the headphone jack as possible ,noting their placement! Remove sum jacketing from the ends of the wires ,and solder them back into place on the new ...

mixer I have a pioneer djm-600 and I'm getting feedback noise from it when Iattempt to record. I've tried both stereo and phono outputs and thesame noise occurs. I have a aluminum plated copper wire i

wire with the issue, but your RCA cables. Try disconnecting both turntables, and connect 1 at a time, and do the same test, this way you can isolate the problem. Once you've isolated the problem, then

...using Serato with the 2 CDJ 400s and DJM 400 with a MACBOOK . Is it neccessary to use the control wires that connects the CDJ's to the mixer? To keep your levels down keep the TRIM don which is the ...

...problems I'm getting a feedback "hum" with only one channel in use. This is a cdj so no ground wires involved. Also I'm only getting mid and treble sounds with both red and white phono leads yet ...

...Unusual fault on a 909, they are usually pretty reliable. I'd 1st check if it is correctly wired - i.e CD into "line" level input and not "phono" or vise versa. ...

...plays out of one channel on my mixer HelloCheck the wiring to the cartridge.  If any one wire amomg four of them will get loose contacted or have a break, that side will not work properly.

...connected into rear panel of mixer plus an amplifier also connected in rear panel. One of your wires is faulty. there is a open ground. Check all your wires, or, one of your devices has a dead ...