...switch in the door gets power from the driver switch and trust me a broken wire in the drivers boot can cause door locks and windows to not work in all the doors even when using the switch on that ...
...door switch when you are pressing the switch. Also check the wire at the window when pressing the driver's door switch. This will verify power going to the switch and power leaving the switch, in ...
Question about 1997 Wrangler
...door switch. Is a connector off of the wiring harness somewhere for this options? My jeep did not have the option of a dome light from the factory. Thanks, Come off the fuse box on a fused circuit ...
...Wiring Diagram Battery Constant 12v+ Positive Wire (+): Red and Pink Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness Starter Positive Wire (+): Yellow Starter Positive Wire ...
Wiring Diagram Battery Constant 12v+ Positive Wire (+): White And White/Red Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness Starter Positive Wire (+): Black Starter Positive Wire
Question about Brand Remote Start/keyless/car Alarm Very Sleek
Wiring Instructions Battery Constant 12v+ Positive Wire (+): Red Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness Starter Positive Wire (+): Purple or Yellow Starter Positive Wire
...wiring The door light stays on. the driver door switch is working as the fuel pump run if door is oppened. It must be one of the other doors. I opened door and found 5 wires, i asume 2 is door switch ...
...door trim and check the wiring and connectors. The wires from the door switch are tan and gray/black and run to the 8 pin connector of the drivers door module. By peeling back the plastic shield, you ...
Question about 1995 Bonneville
door switch? The lights are wired in parallel General wiring illustrations on following link: http://waterheatertimer.org/How-to-wire-door-switch.html Usually the door switch is installed on the hinge
...door and replacing the motor. Or, it could be a wiring problem. You would need a multi-meter to check continuity of the two wires from that door switch to the master controller on the driver's door. ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions