washer won"t fill with water i installed new timer and water inlet valve and washer still won"t fill with water. everything else works fine. check your lid switch if its a top load
WASHER FILLS WITH WATER, THEN WON'T AGITATE. TURN KNOB TO SPIN AND IT DRAINS THEN SPINS. STILL WON'T AGITATE WASHER FILLS WITH WATER, THEN WON'T AGITATE. TURN KNOB TO SPIN AND IT DRAINS ...
...won't stop the fill... had to shut off water source. won't get to agitate phase... just want to stay at fill stage... can drain, spin, not agitating. Sounds like the fill switch needs to be ...
Question about LSR7333 Top Load Washer
...won't fill with water. If I fill it by hand, the cycle works fine (until it gets to the rinse cycle, when it won't fill again). maytag_lse7804ace: washer won't fill with water. If I fill it by ...
Question about LSR7333 Top Load Washer
...at any point, cycle would stop. Now I can't get it to anything but fill with water. Your lid switch has a fault, Sometimes the switch can bend which means that it won't always
Question about LSR7333 Top Load Washer
...won't fill. i filled it by hand with water, it won't agitate either, only spins. model wtw57esvw0 The inlet solenoid is probably bad. And it won't agitate unless it fills and stops ...
Question about LSR7333 Top Load Washer
kenmore washer model #111092581200 won't stop filling and won't agitate kenmore washer model #111092581200 won't stop filling and won't agitate Please recheck that model number
Question about LSR7333 Top Load Washer
...won't spin, will fill and drain Whirlpool LSC8244DQ0 Top Load Washer won't agitate, won't spin, will fill and drain you need a new lid switch google model number and order new ...
Question about LTE5243D Top Load Stacked Washer/Dryer
won't fill with water unless dryer started, will fill with water but won't wash Literally won't fill with water until I turn on the dryer. Now it just fills with water and won;t run I ...
Question about LTE5243D Top Load Stacked Washer/Dryer
won't fill with water (Photo 3). Another likely cause is a clogged inlet screen or faulty inlet valve. ... If it doesn't, first make sure the float valve is operating freely (Photo 3). If this doesn't
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions