Questions & Answers for: Pontiac Sunfire wont start

1997 Pont sunfire turns over wont start the cranks wont start, replace fuel pump, fuel relay, fuse, and oil pressure switch. still no start. will run with starting fuild. replace engine control module

Ad

Question about 2002 Sunfire

1 Answer

wont start after stereo installation car wont start after installation. no fuses blown bvattery is good. Did you install the stereo with an integration module? ...

Ad

...wont start, put new battery in, still wont car wont start, put new battery in, still wont start, any ideas? fuel pump?? coil?? service enginge light on if so hook up OBD 2 Scan retreve codes and fix ...

wont start i have a pontiac sunfire 2.2 somtimes it wont start it will start with starting fluid your fuel pump may be failing. you might need to have it replaced but i suggest you have it checked out

...WONT START AFTER IT rains MY 96 PONTIAC SUNFIRE 2.2LITER WONT START AFTER IT RAINS OR IT WILL STALL OUT AFTER BEING TAKEN THROUGH AUTOMATIC CARWASH ANY SUGGESTIONS ANYONE?? THANKS! check spark plug ...

Question about 2000 Sunfire

1 Answer

It wont start. The battery is good the altenator was just replaced but it would start. It acts like it wants to start but it wont turn over. its your fuel pump a very common problem with those cars

...start it and it gest rolls over and wont start come back in a hour starts right up and spits for a bit then its fine till it wont start again sounds like you have a clogged fuel filter or bad fuel ...

...wont start , ive changed the fuel pump ,fuel filter and it still wont start. now it wont even spark . How can i fix this? Have you checked the fuses and relays ?  Is the check engine light on ...

Question about 1997 Sunfire

1 Answer

shifter not working when i turn the key on everything comes on except the car wont start, shifter was stuck got it un stuck but now it wont let it start u need a new clutch

Question about 1996 Sunfire

1 Answer

1996 sunfire 2'4 wont start the car wont start Battery could be dead. If not then the ground wire could be loose or corroded. Fly wheel could be worn. Crank shaft position sensor could be bad.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...