Questions & Answers for: G5 yamaha pw50 kick start

...pw50 bike for my lad bike seemed to be running fine when i brought it now i am struggling to get it started it does run ok when i get it going . i have put a new throttle cable on new air filter ...

engine dies when choke is relased after 2 years of not use my son's pw50 is having problems to stay running when the choke is relase if trottle is not pull, so when he is riding basically he needs to ...

fuel running out of air intake my boys received a 2nd hand pw50 for their birthday it was runing very well until it stopped and i noticed fuel running out of the air intake as the air filter is off ...

yamaha zuma..it starts first kick.It runs good until half throthel after that it strugle loss power.Carb is brand new ,It shouldnt have had carb problem.I changed the spark,Gas thanks is clean..It has

Stalls at stop signs Every time I stop the Vino Classic 50 stalls out - I have to hold the front brake and hit the electric starter with my thumb while giving it almost full throttle to get it to ...

...kick it ill run for a sec the just cut off Timing is right or it wouldn'trun at all. So now you need fuel and air in the proper amounts. If it's starving for either one it will cause the problem you ...

...start or kick start. It will start with jump leads scooter peugeot v clic 50cc. has new battery. the battery earth to the bikes chasy may be dirty check all battery leads are clean and tight plus any ...

...start my 2005 yamaha banshee will not start. i have spark at the plugs. it done this once before and i clean the plugs and adjusted the gap and worked fine. now i replaced the plugs and no start Did ...

...yamaha pw80 will start and then after a couple of seconds it cuts out make sure enough petrol is getting to your carb, check the fuel line going from your tank to the carb make sure it is completely ...

...kick start even with starter fliod. Anything that I can check or replace? Check fuses. Get a new spark plug then check for spark by hooking up the plug wire then hold the metal side of the plug ...