AEG Cooktops - Recent Questions, Troubleshooting & Support

The igniter is not working and should be replaced and there is also a problem with the igniter as well.

E5 or E0 means that the stove is getting overheated. You have to reduce the temperature for it to stop. It goes on with few beeps and then stops.

even look on google https://www.coolblue.nl/en/advice/zanussi-aeg-induction-cooktop-error.html

It is child lock.

Turn cooker on, press two + at front of oven, this will then take it off for that cooking session.

To turn child lock off switch on hob, and touch - for 5 seconds.

p1 beep sound

If its a Rangemaster induction cooker, I had the same problem and its caused by a Loose or faulty PT sensor under the glass, you need a qualified engineer to rectify it.

prestige induction cooker showing error p with beep sound problem solution

there is a bypass screw on each gas valve. adjust so flame is reasonable when each burner is turned to low

e 3 is error because of high voltage may be more than 30 kW at your house......it will not work with it u have to buy a voltage regulator for it........

It is possible that there is fault in the circuit as the drive section seems to fault when the current requirement is high. It is also possible that there is a component possible a semiconductor- MOSFET- that has gone weak during the power outage and so fails .
It is best to have it checked now as it might save a larger expense if the whole unit fails. Also someitmes it can be a silly dry soldering which can be done up immediately. So get support if youa are not able to DIY.

did you get it fixed?

not sure as to what you can do , if it did get too hot, maybe wrong pan, but could also be wrong temp in unit, only way to find out is to try and use warrenty

child lock is activated , switch on hob press - and + button simultaneously hob will return to normal. if zeros dont appear try pressing and hold - key slightly before pressing +key hold both for a few secs.

Refer to your installer/supplier. The unit has a fault in one of the controller boards that needs to be replaced. It may well be done under warranty.