F11 error warning
Solution1 worked after all steps, but had to cut the power (unplug) and replug, then it startedwell ! Thanks !!!
I had the F3 error code on Asko front load washer. I pulled the coin trap (which I never knew existed) and found a handful of change, paper clips,.a screw, and a couple random plastic doo hickeys. I replaced the filter back into it's original position, twisting to the right. Upon running the next load, water started gushing water from the pump door. Any suggestions?
Hi Jacqueline,the filter will usually have a rubber o-ring gasket to seal the opening to prevent leaks. When you cleaned it,the gasket may have kinked, torn or popped out of the groove that holds it in place. Open the filter and check if the gasket is in place, if not slide it back into the groove and that should stop it from leaking. Also check the small drain hose, make sure the stopper is in. That should take care of any leaks in that area. If the leak continues I would suggest calling a local repair company. Hope that helps.
Asko W6324 over filling
try turning the tap off at the if unplugging the machine didnt work,i would say you water solenoid is stuck open
Asko 12005 washing machine vibrates and banging on side when spinning
The load has become unbalanced. Pause the machine in mid-cycle (do not Stop it) and when it ceases spinning, open it and re-distribute the load evenly. Then press Pause again to continue the cycle. Note: if you Stop it, then restart when finished balancing, the machine will start washing from the beginning instead of continuing from where you Paused it.
Not finding what you are looking for?