Becker Car Audio & Video - Page 8 - Recent Questions, Troubleshooting & Support
Code wait, what doing
When you have WAIT showing on the display this means the radio has been asking for a code and too many incorrect code entries have been made. The radio is locked down because of this. This happens when the power has been lost to the radio and it needs a code to reactivate it.When WAIT is on the display you must leave the radio turned on under constant power with the key in the ignition turned to accessories position on until the display turns to CODE or shows ----. You must leave the radio on for up to four hours with the power uninterrupted. The waiting period depends on how many incorrect codes have been entered. The power to the radio must remain uninterrupted or the WAIT period will start all over again hence the reason why the key must be turned in the ignition to Accessories IOnce you have CODE or ---- back on the display you need to enter the correct code to reactivate it. If you do not have the correct code I suggest you go
here and purchase the code from this website which is one of the few sites I know that can decode Becker radios online. You need to send them the serial number of the radio and they will email the code back to you.Hope it helps. Thanks for using FixYa.
1/7/2015 9:08:39 PM •
Becker...
•
Answered
on Jan 07, 2015
How to insert a car radio code on a Becker radio in a Vito van that only has rotating dials and no pre-sets
If you are trying to fit this radio to a different vehicle, then you may find yourself with the Error message of "PROD". This stereo is electronically paired, or "Married" to the engine management system of the vehicle it came out of using very sophisticated CAN-BUS system technology.
When it is first powered up, it will communicate with the vehicle, and whilst this process is in operation the set will appear to function correctly, and if communication has been successfull, it will continue to operate in the normal way.
However, if removed and refitted into a different vehicle other than the original one, it will not recognise the encrypted CANBUS identification of the new car, and will instead display an error message of "PROD" after around 30 seconds.
This Radio cannot therefore be transferred from one car to another, unless it has first been reset back into its original "Delivery Mode" with the internal CAN-BUS data memory reprogrammed for use with the new vehicle.
and yes that code for that serial but i dont think your need that
P1015401
P1015401
Model-No. BE 1150
Posted by J Lopes on Aug 16, 2014 code 23114
Not finding what you are looking for?