Behringer Audio Players & Recorders - Page 8 - Recent Questions, Troubleshooting & Support
Behringer B215A replaced volume level knob does not respond.
You DON'T replace the board. If it is cracked, you bridge insulated wires around the cracks and epoxy them down.
Often the pads break from the traces near the pots. Look for a small crack between the pad of the pot and the circuit trace leaving it. Common problem.
6/15/2015 11:04:30 PM •
Behringer...
•
Answered
on Jun 15, 2015
How to replace Behringer Eurolive B215A Amplification
Is there any fuses inside the unit or just the one on the back inside that cylindrical fuse holder that you can push, twist and remove? Mine will not power and I want to open up the box if there is any fuses there and I will check for cracks near the pots, etc. as well while I am inside the power box. I already removed the box fromt heback. Just need to open it up now.
I have a Behringer b215a
Were the fuses blown when you took them out? Did it blow the new fuses too? If so, your internal amps are fried. They can be fixed by a technician.
6/8/2015 1:24:35 AM •
Behringer...
•
Answered
on Jun 08, 2015
What caused my board to short out, and stop working. Lights just blink, and both fans on the back stop working...
the reason it is doing this is there is a fault on the output board, and it is going into protect mode. check the usual suspects, output transistors, driver diodes, and bias resistors. if none of the easy to replace components are shot, replace the circuit board, as this board is surface mount, there is very little hope of repairing it cheaper then replacing the whole thing. sorry
3/9/2015 12:20:57 PM •
Behringer...
•
Answered
on Mar 09, 2015
How do i hook up my laptop and my tablet to a behringer Europower PMX 2000
Easy to do - just get a patch cord that has a stereo 1/8" plug on one end and two phono (RCA) plugs on the other end. Plug the phono plugs into the "Tape IN" jacks on the mixer and use the "Tape" volume to adjust the sound level. It's best to turn your laptop or tablet volume up to maximum, then adjust the volume on the mixer.
I have pioneer sx 20 tuner/amp and behringer ultragragh pro fbq 1302 graphic equaliser linked together with mono cables via tape i/o rca ports lights on graphic eq lights in sync with sound on sliders
It is a bit fuzzy for me, how everything is connected, but just plugging in cables where they fit won't always work. Special not with tulip plugs and cables.
Not sure you Amp has speaker switches, but you could start there. NEVER switch on an amplifier, while the volume button is open. Not even when it is half way. Please every time you want to change something, first lower the volume.
First try to get any sound from the amplifier in the speakers. When you have something like noise in the speakers, then you can test an input on the amp. You could put in a pice of wire in and choose the correct input button and then turn up the volume.
If it starts humming, you are on the correct input. On that input you plug in a device giving enough power (voltage must be within the range for that input) and check if it works.
When you want to know anything about voltages going in an amplifier I add a wiki page, and for all other inputs you can find the levels on Wiki too.
Line level Wikipedia the free encyclopedia
Not finding what you are looking for?