Adhesives, Coatings & Sealants - Recent Questions, Troubleshooting & Support


Elasto Patch is an Exterior waterproofing product in the family of Elastomeric coatings used on stucco-

Cut it off the wall with a sheetrock knife and back fill it with All Purpose Joint Compound then skim coat it with Topping compound-

Perry Tradesman

Dap 12288... | Answered on Nov 03, 2019


sounds like off gassing. I suspect 1 of the following:
1. you didn't wait for the adhesive to dry to tackiness before applying
2. it's in direct sunlight or in a hot area
3. the material for the map is very thin and/or stretchy

3M 77 16.5-oz.... | Answered on Sep 13, 2019


Lots. Probably at least 60 and as many as 100. Check your local zoning laws.

Eternabond Rv... | Answered on Jul 13, 2019


There are two types of glue stick.

One that is like lipstick, you remove the lid, twist the bottom and the glue stick pops up for you to rub on the paper.

And Glue Sticks for glue guns. The look like a hard plastic and when inserted into a glue gun, the head heats up and glue comes out when you pull the trigger.

which do you have?

lipstick
https://www.staples.ca/en/Staples-Glue-Sticks/product_SS2000808_1-CA_1_20001?CID=PS:GS:CA:b:dsa-459928529927::54049798957::1352059385&CampaignID=1352059385&gclid=Cj0KCQjw9JzoBRDjARIsAGcdIDVJajEt1C2oZtfc79X0IMMZoTp7AJCFhvJLQWSh6jOb6vHGenOtsh4aAjCBEALw_wcB

sticks
https://www.staples.ca/hot+glue+sticks/directory_hot+glue+sticks_20051_1_20001

Staples Washable... | Answered on Jun 17, 2019


enough for 16 cubic inches, or one pint.

West System... | Answered on Jun 17, 2019


All the codes are here. However, the modern way is to buy a facsimile remote that is the same as the original.
3 Digit Universal Remote Codes For TV Codes For Universal Remotes

https://www.remotes.com/default.asp?gclid=Cj0KCQjw9JzoBRDjARIsAGcdIDVyzVcKSILhu9831vTQ6uJf7fBh7NRaa_9BPKiYbumQb3icIpE86iUaAj2_EALw_wcB

Maxess Climate... | Answered on Jun 17, 2019


Razor blade scraper or a craft knife with the snap off blades, but very carefully. Once you have a very thin layer, you should be able to rub it off with a rubber glove.

The process for removing silicone caulk residue is simple, but it does take some time and effort.
  • Use a razor blade to scrape off as much of the residue as possible without scratching the surface you are cleaning.
  • Apply mineral spirits or denatured alcohol. ...
  • Brush away any bits that "pill" and become detached.
More items...

How to Remove Silicone Caulk Residue ' Hunker


 https://www.hunker.com/13416875/how-to-remove-silicone-caulk-residue

videos
https://www.google.com/search?q=remove+old+caulk+residue

Silicone I... | Answered on Apr 03, 2019


Use common acetone-based nail polish.

Grobet SUPER... | Answered on Apr 02, 2019


There is no effective long term way to store tubes of silicon. Even unopened tubes have a finite shelf life. I have found the most effective way to store opened tubes for medium lenght time, is to allow a bit of excess to flow over the tip, and allow it to form a plug. In a few months, this plug may extend the full length of the nozzle, but you can push this out with a piece of steel rod (from the tip end). I keep my tubes of silicone and caulking in a cool dry place. I've never tried the bucket of water method, so I don't know how successful that would be.

Adhesives,... | Answered on Jan 02, 2019


First start the cleaning process, clean all dirt and debris from the concrete driveway surface. Use concrete caulking or concrete sealer to fill the crack. With the help of troweler fill the crack properly and make smooth surface. Now let the driveway be dry. Now coat the concrete driveway with concrete sealer oil-based polyurethane to make the driveway water-resistant. Finally you can use colored concrete patching compound to match with the previous driveway color.

Adhesives,... | Answered on Sep 21, 2018

Adhesives,... | Posted on Mar 29, 2018 | Be the first to answer


On pre-mixed buckets, a lot of dry-wallers add just a little water and whip it up when tape and texturing. It flows of the blade better. But, if you're just repairing a few holes, dings and gouges, then no real need............unless it's really thickened up on you.
If you have a partial bucket and are not going to use it for a while, you may want to flick some water on the surface and lay Saran wrap on the surface, then cap the bucket.

Adhesives,... | Answered on Mar 12, 2018


Hello below is answer:
Curing Time: The cure of Loctite PL S10 varies with temperature and humidity. The following times assume 75° F (24° C), 50% relative humidity, and a joint ½" (13 mm) wide by ¼" (6 mm) deep. Skins over: overnight or within 24 hours Full cure: approximately 7 days.

Loctite PL S10... | Answered on Dec 15, 2017


The best product that will not harm the poster or window is silicone caulk. There are also some crystal clear adhesives made from silicone now available.

Adhesives,... | Answered on Nov 19, 2017


Soak it in water for a day then rub it off.

Tulip Fashion... | Answered on Nov 02, 2017

Tip

How to get superglue off fingers


Through necessity when nothing else was available, I found that acetone / nail polish remover dissolves or at least softens superglue.
After the back of a folded tube burst, hands covered in the stuff, I tried various products.
Hand soap, dishwasher, Handy Andy and Methlylated spirits have little effect.
Laquer thinners also helps a bit, although acetone seems best.
Pour full bottle into glass or metal container - not plastic, which will melt..
When rinsing hands in acetone, rub & scrub to remove stubborn bits still stuck.
Concentrate under fingernails, where skin and nail meet.
After removal, re-bottle actetone for future use.
Lanolin oil in skin will also be removed, so after acetone-bath, wash well with hand soap, rinse, treat skin if required with a moisturizer cream.
If your'e a guy, live with it - it'll give your hands a manly, rugged outdoor look! :)

on Oct 19, 2017 | Adhesives, Coatings & Sealants


If it's a mobile home he probably has it 2-12 pitch roof I would use roll roofing instead of shingles hope this helps

Adhesives,... | Answered on Mar 19, 2017

Adhesives,... | Posted on Oct 13, 2015 | Be the first to answer


no this is overkill. the seem tape is only necessary for seems, screw holes can be covered by a coat of joint compound, and sanded smooth after it dries

Adhesives,... | Answered on Jul 27, 2015


They're not the same thing, spackle is used to fill in holes or indetations made from nails in drywall while joint compounds are used to join drywall panels together.

Adhesives,... | Answered on Jul 27, 2015

Not finding what you are looking for?
Adhesives, Coatings & Sealants Logo

155 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

MISC 35403 - Gel SuperGlue 3 gm Tube
MISC 35403 - Gel SuperGlue 3 gm Tube

0 Questions

Roberts 2 Gal. Wood and Bamboo Flooring Superior Grade Adhesive R1509-2
Roberts 2 Gal. Wood and Bamboo Flooring Superior Grade...

0 Questions

Roberts 7200 30 fl oz. Wall Base Adhesive, Superior Grade, in Caulking Tube 7200-30C
Roberts 7200 30 fl oz. Wall Base Adhesive, Superior...

0 Questions

Artbeads.com E6000 Glue 1oz Tube - Medium/Clear
Artbeads.com E6000 Glue 1oz Tube - Medium/Clear

0 Questions

Loctite PL S10 Polyurethane Concrete Crack & Masonry Sealant
Loctite PL S10 Polyurethane Concrete Crack & Masonry...

0 Questions

Top Adhesives, Coatings & Sealants Experts

Frank

Level 2 Expert

139 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

29768 Answers

Richard Piatek
Richard Piatek

Level 2 Expert

97 Answers

Are you an Adhesive, Coating and Sealant Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...