Rock & Ice Climbing - Page 2 - Recent Questions, Troubleshooting & Support
What sort of gun I will get in the range of $200 and $300?
The guns that are available in this range are usually the Classic Army M14 and M16s. These look like the good old army guns and are quite popular. This category of price actually marks the beginning of the good quality guns. From here, the higher you move up the price graph, the better guns you buy. You can do airsoft upgrades to make your gun much more real.
Continue reading :
Welcome to Airsoft Club
12/30/2016 6:58:35 AM •
Ics MP5A5...
•
Answered
on Dec 30, 2016
What are the major guide lines before buying a airsoft gun?
Getting involved in one of the fastest growing recreational activities can be great, which is known as airsoft guns. But before you buy such a gun for yourself, you must equip yourself with all the necessary information so that you get the gun that meets your requirements. Get all the vital information
here
12/29/2016 7:54:49 AM •
Ics MP5A5...
•
Answered
on Dec 29, 2016
What are the latest airsoft upgrades?
The latest electric gun in today's market is the hybrid gun of airsoft. The hunting and shooting process can be done properly with the use of these hybrid guns. Laser sightings and torches are used for comprising the parts of
Airsoft gun.
12/29/2016 7:48:58 AM •
Ics MP5A5...
•
Answered
on Dec 29, 2016
How do you deactivate demo mode on the buglit?
Demo(factory) mode is deactivated by holding the switch on for approximately 20 seconds, until light flashes and goes out.
Normal function is press once for high, a second quick press for low, a third press for strobe.
Where are the answers?
1. In order to wind a bobbin you must transmit a design to the machine, as well as send a block to your sewing machine.
2. If no design has been transmitted and no block of color sent, the bobbin winder will not work.
3. Replace the embroidery thread on your spool pin with Bobbinfil thread, wind the thread around the thread guide located over the transparent threading path on the top of your machine and then slip the end of the thread through the opening in the bobbin from the inside to the outside.
4. Place the bobbin on the bobbin winder shaft and push the shaft towards the right.
5. Hold the thread end securely above the bobbin, and then press the green operation switch on the front panel of your machine to begin winding. (The foot control is inoperable with the embroidery unit attached)
.
6. Allow the bobbin to turn several (10 to 12) times and then stop the machine by touching the red operation switch on the front panel of your machine. Cut the thread at the top of the bobbin as close to the bobbin as possible. Continue to wind the bobbin.
7. The bobbin will stop turning when it is full. Push shaft to the left, clip the thread and remove the bobbin from the shaft.
8. Remove the hoop from the machine, (DO NOT REMOVE YOUR FABRIC FROM THE HOOP), replace the empty bobbin and then re-insert the hoop.
9. If your design moved forward a stitch or two when you picked up the bobbin thread, you can use the backstitch operation switch on the front of your machine to move back to your original position.
Not finding what you are looking for?