Dishwashers - Recent Questions, Troubleshooting & Support


Stick a soft wooden stick in there and swirl it a bit. The other option is to add vinigar and do a short wash for the sensor inside cleans up. Last option would be to remove larger cover and check for obstructions and connections

Thermador... | Answered Yesterday


f code is a fill fault problem to much or to little water to determine the problem is to hit cancel drain buttons on the front of the machine and wait for cl on the display turn off machine and wait 30 seconds turn back on and the first thing you will hear is the drain motor turn on for 15 sec then you should hear the water filling into the machine if you dont hear water filing then check to see if the valve under the sink is open to allow water to fill machine

Thermador DWU244... | Answered Yesterday


Hello. From what you describe, the detergent dispenser has become defective and needs to be replaced. Normally, if run daily, you should get a week's worth of washings before needing to fill the compartment. Make sure, if there is a setting dial(with an arrow) inside the rinse aid compartment, that the arrow should be at 2 1/2 to 3, give or take a little. You don't want too much rinse aid in the water as it can cause a severe foaming of the water which can trigger a drain error--the unit thinks its draining water when, in fact, its sensing foam and stays on too long. The main board senses this and triggers a shutdown for safety. Washing machines can experience this same phenomenon from too much detergent--its called a SUD error, for too much suds in the water.

Dishwashers | Answered 2 days ago


Hello. The control panel most likely wasn't the problem...the main control board probably was blown out causing the user interface to remain off. What was the unit doing or not doing that made you replace the control panel?
BIG TIP--if you had a power interruption (such as lights dimming in the house--called a "brownout") or a full scale outage where the clocks reset, the main board very well could have been damaged by the current surge when the power came back on. *NORMALLY**, if the appliance wasn't damaged immediately, 4-6 weeks after the event, strange things will start happening or not happening with appliances because chips on the the board were damaged and start to fail. I tell all my customers to check into WHOLE HOUSE SURGE PROTECTORS--you can buy them at Lowe's or Home Depot and, your power company might install them on your house for a little extra on the bill each month--money well spent!

Bosch... | Answered 2 days ago


USE BRAIN WHO MADE IT WHO SELLS IT WHO SERVICES IT

Bush Dishwashers | Answered 2 days ago


NO IDEA HERE TRY LOCAL REPAIR SERVICE

Miele... | Answered 3 days ago


Fault in thermal cutout or heating pause fault. Selected temperature not reached in 90 minutes
?· Check heating element
?· Check thermostat

Westinghouse... | Answered on Jan 20, 2020


Hi,
Here is a tip that will help you to find out why water will not come into the dishwasher...
Dishwasher Trouble No Water entering Dishwasher
http://www.fixya.com/support/r4021363-dishwasher_trouble_no_water_entering

heatman101

Bosch 24 in.... | Answered on Jan 19, 2020


Does it cycle i.e. fill, wash, rinse, and drain?

If yes, then heater relay likely has failed (closed).

What model number?

GE Dishwashers | Answered on Jan 18, 2020


Hello, cynthia

I was trying to help you out here. Maybe this will help some? I was going back to some customers that asked questions in the past and it appeared that no one answered them, so I thought I would take some of my personal time to see if I can help. Even though this site may not have your exact model or brand, This link will help you tons. Here is a link to about everything you want to know about your dishwasher, from repair to trouble shooting it,pictures, video's. Just scroll around and you will see tons of information to almost any question you might have on your dishwasher. If you go to this link and click around, I am sure you will find out so much about your dishwasher, you will know more that the company that made it. Here Is the link for you to click on>>

http://home.howstuffworks.com/dishwasher.htm


Please if this helped you at all, if you can find the time to rate my help and some kind words written would be appreciated for my free help , I would appreciate it. Here is also my direct link to my own pages of other areas of my expertise for other problems you might have in Automotive,Appliance, and Electronics. Drop In anytime for my help. Thanks,Mike

http://beta.fixya.com/users/mc1bean

Danby DDW497W 22... | Answered on Jan 15, 2020


Experienced finance professional with a background in various industry sectors, including the service sector, construction, retail and manufacturing. Working up through the different levels in finance from the very bottom to a qualified accountant with over 25 years experince. Because of this, I understand how difficult it can be for clients with regards to finance and the necessary HMRC compliance and keeping on top of changes, for example Making Tax Digital.
My aim is to offer a top level personal service keeping the service costs realistic and fair; as an accountant St Neots .

Dishwashers | Answered on Jan 15, 2020

Not finding what you are looking for?
Dishwashers Logo

90,850 questions posted

Ask a Question

Usually answered in minutes!

Top Dishwashers Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Brad Brown

Level 3 Expert

18157 Answers

Cindy Wells

Level 3 Expert

6065 Answers

Are you a Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...