Drills - Page 7 - Recent Questions, Troubleshooting & Support

It's a blown fuse inside the battery

The batteries have worn out for your drill and can no longer be charged anymore and you will need new batteries also. Or there might be something wrong with the charger as well.

There is a one minute video, but it is a 30 minute videos speeded up! The fill cap takes a large Allen key. It is not the cap under the bottom of the gearbox, it is situated in the top of the drill. https://www.google.com/search?q=Hilti+TE+17+Oil+change ..

You can use an AW46 Hydraulic oil. Do not put more than 35cc of oil in tool if you just poured out the old oil. You can put 50cc if you washed the housing out. Too much oil takes out the cushing of air between pistons. You will break the connecting rod or strip the gears. If you take the cap off of the top of the gear housing, older ones will be black. Newer ones had a red cap indicating that there was a clutch and see and it still looks wet with oil then I would not mess with it.

The new line-up of CRYSTA-Apex series CNC coordinate measuring machines

the header lists 2 different tools but if you give me the model number I will find a cord set for you and the wiring diagram that you need. If you also give me the area (US only) I will try and find someone local that has what you need.

Use a table vise.

That particular battery is defective and falsely indicating it is charged.

You can search it online or go to Electronics store.

There are two screw that attach the motor to the impact head andit seems they have a habit of backing themselves out. the torque of the motor cause the motor to begin rotating in the plastic housing and eventually it pulls the wire out of the back of motor.. I buy and sell tools and almost every one I've found not working it is because of the same problem. couple screws some soldering and threadlock and $$ I bought 3 for 5 $ at fleamarket last week.

Take the battery off and look under there for the sticker with serial number on it :-)

https://www.fixya.com/support/t24996454-remove_chuck_super_hawg

https://www.youtube.com/watch?v=EHcBKWVLfmU https://www.fixya.com/support/t24996454-remove_chuck_super_hawg

Hi, depending on the age of your device, it might be time to switch the battery of the product if the current battery isn't strong enough to hold a charge. Thank you.

Take a look for warranty, and contact them ... If your warranty is out of date, than you must get new one. The best place is amazon for sure, Milwaukee 48 11 2830 M28 Lithium Ion Battery Pack. Hope this was helpful, cheers

Have you tried a tool repair service? My husband is always seeking advice from the tool professionals. Due to constant use, his chargers stop working often and, although he is a handyman himself, there are times when his own knowledge isn't sufficient. bourgetbros com

You can get a replacement 9.6v bosch battery here

bosch battery

My problem is which wires connect to which terminals on the new switch.

binding or overheating ---try lubing the gears-motor and anvil

Hi. My hilty te75 lose force in hammer. my email is [email protected]